HOBBES LANtest Kit Manual descarregar pdf (Página 5)

LANtest Kit

3.2 For the remaining testing procedures, please refer to steps 1.2

to 1.5

Note:

1. The center pin of BNC should be read on LED 2.

2. As Coaxial cable has only two wires, we suggest you read

the result of the LED scan using Manual mode.

II. Remote Test

1. Plug one end of the tested cable to the transmitting RJ45 jack on the

master unit marked with a ' ' and plug the other end into the remote

terminator. If the tested cable is installed in a patch panel or wall

plate, you may use the included patch cable to solve the connector

gender problem.

2. Now, set the Auto/Manual switch to Auto mode for one-person

testing.

3. Read the test results from the LED display on remote terminator.

Note: The LED display on the remote unit will scan in sequence

corresponding to the transmitting end of the master unit.

Remote Test

Sample Test Results

1 2 3 4 5 6 7 8 G

1.Continuity: Pin 2 has continuity

1 2 3 4 5 6 7 8 G

2.Open: Pin 2 is opened

1 2 3 4 5 6 7 8 G

3.Short: Pin 2 and Pin 3 are shorted

1 2 3 4 5 6 7 8 G

4.Miswire: Pin 3 and Pin 6 are miswired

Caution:

1. Operating the tester in live circuits may damage the tester

2. Leaving the battery in the tester for long periods of time without use

could drain power from the battery

1 2 3 4 5

Sem comentários

HOBBES LANtest Kit Manual Página 5