HOBBES LANtest Kit Manual descarregar pdf (Página 4)

LANtest Kit

PRODUCT PROFILE

I. Loopback Test

1. 10Base-T Test

1.1 Plug one end of the tested cable into the transmitting RJ45 jack

on the master unit marked with a ' ' and the other end of the

cable into the remaining receiving RJ45 jack.

1.2 Slide power switch on. The upper row of LEDs will start to scan in

sequence if the Auto/Manual button is set on "Auto" mode. The

LED for pin 1 will light up if the button is in "Manual" mode.

1.3 Switch back and forth from Auto or Manual scanning mode by

pressing the Auto/Manual button on the side of the master

testing unit.

1.4 Once both ends of the cable are plugged in properly, the second

row of LEDs will illuminate according to the corresponding LEDs

in the top row.

1.5 Read the results of the LED display for the pin configuration

status of the tested cable. If you fail to read the results the first

time in Auto mode, you may wait for the second LED scan, or

simply switch to Manual mode for pin by pin testing. In Manual

mode, pressing the square "Test" button will advance testing to

the next pin.

OPERATION

Note: Make sure the battery power is sufficient. Insufficient

battery

power will lead to dimmed LEDs and incorrect results.

2. RJ11 Modular Cable Test

2.1 Please follow directions for the UTP/STP Cable Test and use the

operations manual for the correct LED pin out display

3. Coaxial Cable Test

3.1 Plug the two attached BNC adapter cables on both RJ45 jacks.

Then connect the tested cable to each end of the BNC adapter

cables

1 2 3 4 5

Sem comentários

HOBBES LANtest Kit Manual Página 4